Chapter Iintroduction - Enerco Heatstar HS25NG Notice D'utilisation

CHAPTER I
INTRODUCTION
1. EQUIPMENT
This heater is the consumer version of our highly
successful, thoroughly tested, gas fired, infrared,
industrial utility heater.
This heater does not require an external electrical
source for operation.
The major components of the heater and a typical
installation are identified in Figure 1. The basic
Model # HS25NG/LP
GAS CONTROL
VALVE
POWERPILE
GENERATOR
THERMOSTAT
CABLE
THERMOSTAT
Figure 1. Heater Major Components
heater consists of the complete burner assembly, flue
deflector, grid, reflector assembly and face guard.
2. PURPOSE OF EQUIPMENT
WARNINGS
This heater is for indoor installation only.
This heater is designed to heat indoor areas. Do not
use for inhabited or small, enclosed areas.
BASIC HEATER
WALL MOUNTING
BRACKET
Installation instructions and Owner's Manual
E3
EXHAUST
VENT