Maintenance - DENIA DC-100 Instructions D'utilisation Et D'entretien

Installation and safety instructions
for AC/DC built-in devices

4. MAINTENANCE

– Never perform repair work on the device. Send the device to ebm-papst for
repair or replacement.
WARNING
Terminals and connections may be live even with the device
switched off.
Electric shock
Wait five minutes following all-pole disconnection of the
voltage before touching the device.
WARNING
If control voltage is being applied or a specified speed value
has been stored, the device will start up again automatically,
e.g. after mains failure.
Risk of injury
Keep out of the danger zone of the device.
When working on the device, switch off the mains power
supply and secure against renewed switch-on.
Wait for the device to stop.
After working on the device, remove any tools or other objects
used.
WARNING
The motor may start up again automatically if the control
signal of a device connected to the mains ceases to be
applied.
Risk of injury
When working on the device, switch off the mains power
supply and secure against renewed switch-on.
Wait for the device to stop.
WARNING
Device still electrically charged following switch-off
Risk of electric shock on contact
Wait 5 minutes following all-pole disconnection of the voltage
before touching the device.
ebm-papst Landshut GmbH ● Hofmark-Aich-Str. 25 ● 84030 Landshut, Germany ● Phone +49 871 707-0 ● Fax +49 871 707-465 ● info3@de.ebmpapst.com ● www.ebmpapst.com
Page 5/5