Attaching The Lead Wires; Electrode Selection And Care; Tips For Skin Care - Grafco GF-TX5 Manuel D'utilisation

ATTACHING THE LEAD WIRES

WARNING: Ensure the device is OFF before connecting the lead wires.
WARNING: Never insert the lead wire plug into an AC power supply socket.
Personal injury and/or damage to the TENS unit could occur.
s CAUTION: Use care when you plug and unplug the wires. Pulling on the lead
wire instead of its insulated connector may cause wire breakage.
The lead wires provided with the device insert into the ports located on the
top of the unit. If only one lead will be used, plug it into the channel 1 port.
After connecting the wires to the unit, attach each wire to an electrode.
Lead wires provided with the device are compliant with mandatory compli-
ance standards set forth by the FDA.

ELECTRODE SELECTION AND CARE

Using Electrodes
Use the electrodes as prescribed. Follow application procedures outlined in
electrode packaging to maintain stimulation and prevent skin irritation. The
electrode packaging provides instructions for care, maintenance, and proper
storage of electrodes.

TIPS FOR SKIN CARE

Good skin preparation is important for effective and comfortable use of your
TENS device.
• Always clean the electrode site with mild soap and water solution, rinse
well, and dry thoroughly prior to any electrode application.
• Any excess hair should be clipped, not shaved, to ensure good electrode
contact with the skin.
• If a skin treatment or preparation is recommended by your physician /
clinician, apply the skin treatment as recommended, let dry, and apply
electrodes as directed. Following these recommendations will both re-
duce the chance of skin irritation and extend the life of your electrodes.
• Avoid excessive stretching of the skin when applying electrodes. Proper
8