Purmo RADSON MINORCA HYDRONIC VERSION Manuel D'installation Et Entretien page 7

INSTALLATION AND MAINTENANCE OF YOUR TOWEL RAIL
2. OPERATING INSTRUCTIONS OF YOUR TOWEL RAILS
To make the most of your towel rail and for greater comfort, we would ask you to take the following
recommendations into account:
2.1 Positioning
• The diagrams below show the appliance's correct positioning.
fig. 1
The appliance must be installed on a vertical wall and the power cable must be located at the bottom.
· Figures 1 and 2 below show the correct positioning of the radiator,
· The radiator should be mounted on a vertical wall with the connection cord at the bottom of the radiator,
· The lower part of the radiator must be within a minimum distance of 150mm from the ground,
· The radiator must not be installed within 50mm of a wall or underneath a power outlet,
· Improper installation of a shelf above the radiator must be carried out over 150mm of it,
· It is recommended to perform the installation, if possible, close to locations with high heat losses
(windows etc) and using screw fasteners appropriate to the nature of the wall,
· Drill and plug the 4 fixing holes in a suitable location,
· Secure the radiator to the wall using the screws supplied,
· Make the electrical connection.
2.2 Brackets
For the correct installation of radiators it is essential that the fixing of the radiator
is carried out in such a way that it is suitable for intended use AND predictable
misuse. A number of elements need to be taken into consideration including the
fixing method used to secure the radiator to the wall, the type and condition of
the wall itself, and any additional potential forces or weights that may happen to
be applied to the radiator, prior to finalising installation.
• For correct heater installation, when the appliance is located close to a wall, it is essential to leave a
minimum distance of 250 mm to access the installation.
• Use bracket screws suited to your type of wall, secure the heater on the wall using the screws
provided with the towel rails.
• The towel rail must be installed on a vertical wall using the wall mounts supplied.
• The towel rails' mounting components are adjustable vertically, horizontally and as regards depth (see
exploded diagram in the box), which makes correct installation easier. Positioning can be seen from
the figure on the drawing page.
v2_M16MI336_A05_1217_MINORCA_MULTILANGUAGE.indd 7
fig. 2
M16MI336 - A05 - 12/17 | 7
3/01/18 09:35
EN