Lubrication - GMC GS36USB Mode D'emploi

Maintenance
WARNING: Ensure the Trigger (10) is locked before performing maintenance.
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool's charger, prior to each use, for damage or wear. Repairs should be
carried out by an authorised GMC service centre. This advice also applies to extension cords used with this
tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and shorten the
machine's service life. Clean the body of your machine with a soft brush, or dry cloth. If available, use
GB
clean, dry, compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol, petrol or strong
cleaning agents
• Never use caustic agents to clean plastic parts

Lubrication

• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Storage
• Set the Forward/Trigger Lock/Reverse (5) to the Trigger Lock (middle) position before storing
• Store the tool with a full battery charge. Recharge the tool every 3 months if stored long term and not used,
which will preserve the battery life
• Store this tool and its accessories in its case carefully in a secure, dry place out of the reach of children
• Store out of direct sunlight
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional and are
not viable for repair.
• Do not dispose of power tools or other waste electrical and electronic equipment (WEEE) with household
waste
• Contact your local waste disposal authority for information on the correct way to dispose of power tools
10