Care And Maintenance - Linea 2000 Domo DO906K/N Mode D'emploi

DO906K/N
around the cabinet. Keep the rear of the refrigerator 127mm away from the wall.
Location
1. Select a place with a strong, level floor.
2. Allow 13 cm of space between the back of the refrigerator and any adjacent wall.
3. Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat
sources nearby will cause higher electricity consumption.
4. Avoid very moist places. Too much moisture in the air will cause frost to from very
quickly on the evaporator, and your refrigerator.

CARE AND MAINTENANCE

Cleaning
Disconnect the power supply before cleaning
Wash ice cube tray, drip tray, and shelves in a mild detergent solution, then dry and
wipe with a soft cloth. Clean the outside with a soft damp cloth..
TEMP CONTROLLER
The temperature inside the refrigerator could be adjusted by the thermostat.
"0"position stands for stopping operation, Set the temperature by turning the
thermostat knob at the back of the unit clockwise.
DEFROSTING
Defrosting of your refrigerator should take place whenever ice build-up inside
the freezer compartment reaches "6mm"thick. Defrosting may take a few hours,
depending on the amount of accumulated ice and ambient indoor temperature. To
speed-up the defrosting process, remove all frozen section. Leaving the door partially
ajar for a "short" period of time will also speed-up the process.
Important: You must remember to close the refrigerator door before the defrost cycle
terminates and normal operating conditions resume automatically. The drip tray should
be in position directly below the freezer compartment to catch evaporated water
during defrosting.
Important Notice: Never use sharp or pointed instruments to defrost/remove ice from
the evaporator/freezer compartment. The evaporator/freezer compartment contains
refrigerated gas lines and if accidentally punched/pierced,will render the refrigerator
inoperable and "void" the manufacturers warranty. Do not allow the refrigerator to
continue operation if the freezer compartment is pierced. After defrosting is complete,
set the control to maximum for 2 to 3 hours before turning to the desired position.
When the refrigerator is not to be used for a long period of time, disconnect the
appliance from the electrical supply and leave the door partially open. This will help
to reduce mold and mildew build-up.
Note: Wait 3 to 5 minutes before attempting to restart the refrigerator if operation has
been interrupted.