Preparing The Unit - Floorpul W1 Mode D'emploi

EN IT
hered with (Legislative Decree No. 151 dated
25/7/05 - 2002/96/CE - 2003/108/CE)
Electrical equipment has a symbol
bearing a crossed out wheeled bin.
The symbol indicates that the appa-
ratus was introduced on the market
after 13 August 2005 and must be
disposed off separately.
Improper or illegal disposal of such equip-
ment or using it incorrectly, can be hazard-
ous to persons and the environment due to
the substances and materials contained.
Administrative and criminal penalties will be
imposed for non-compliance with standards
pertaining to the disposal of electrical waste.
REFERENCE
LEGISLATIONS
The apparatus has been designed in accord-
ance with the Machinery Directive in force
and with the standards set out in the EC Dec-
laration of Conformity supplied with the unit.
UNPACKING
After removing the package as indicated in
the instructions shown on the package itself,
check the integrity of the unit and all compo-
nents supplied.
If any evident damage is noticed, contact the
retailer or an authorised technical support
centre.
PREPARING THE
UNIT
Checking the filter systems
- Release the lever (1 Fig.1) and remove
the cover (2 Fig.2) together with the pa-
per bag (3 Fig.2).
- Remove the cloth filter (4 Fig.3) and en-
sure that the filter cartridge is mounted
inside the unit (5 Fig.4).
- Set the cloth filter back in place (4 Fig.3)
and remount the paper bag (3 Fig.5) on
the cover (2 Fig.5). Whilst keeping this
in place, put back the cover (2 Fig.6) by
hooking the slot (6 Fig.7) found on the
cover onto the metal strip (7 Fig.7) found
on the body of the unit.
- Block the cover in place by means of the
lever (1 Fig.1).
Assembling the pipes
- Insert the sleeve (8 Fig.8) of the flexible
pipe supplied into the air suction hole (9
Fig.8).
- Hook the rigid extensions (11 Fig.9) to the
ergonomic handle (10 Fig.9) of the flex-
ible pipe.
- Hook the accessory required (suction in-
let, brush, crevice tool, etc.) to the rigid
extensions (11 Fig.9).
Positioning the power cable
- Form a ring with the power cable, hook it
onto the tooth (12 Fig.10) and place it as
shown in picture 10.
Positioning the unit onto your shoul-
ders
- Lift the unit and place it on your shoul-
ders.
- Use the buckle (14 Fig.11) to adjust the
shoulder straps (13 Fig.11).
- Use the buckle (16 Fig.11) to adjust the
belt (15 Fig.11).
NOTE:
Elastic straps (17 Fig.11) are found on the
belt (15 Fig.11) and these are used when
placing accessories such as the brush, the
crevice tool, etc.
EN - 2