4�2 Operating Instructions; Important - Dantherm HPP-i Série Manuel D'installation

4�2 OPERATING INSTRUCTIONS
Remember that at startup there is a 1 minute time delay before the heat pump starts
a� Screen lock
1) Press for 3 seconds to lock or unlock the
screen. The buttons will turn dark when the controller
is locked
2) Automatic lock period: 30 seconds if no operation.
b� Power on
Press for 3 seconds to unlock screen.
Press to power on heat pump.
c� Temperature setting
Press and to display and adjust the set
temperature.
d� Mode selection
1. Heating/Cooling/Auto
Press to switch between heating,
cooling, and automatic modes.
Mode Symbol
Heating
Cooling
Auto
1007332 ISSUE 5

IMPORTANT

Water temperature
setting range
18-40°C
12-30°C
12-40°C
e� Speed Mode selection
Press to switch between Boost mode
Whisper mode.
Default mode: Boost.
Please choose Boost mode
f� Wi-Fi
When the screen is on, press
after flashes, enter Wi-Fi connection.
Connect Wi-Fi on mobile phone and input password,
then control equipment by Wi-Fi. When APP connects
Wi-Fi successfully light is on.
g� Defrosting
1. Automatic defrosting: When the heat pump is
defrosting, the lamp flashes; after defrosting
the lamp stops flashing.
2. Forced defrosting: When the heat pump is heating
and the compressor has been running continuously
for at least 10 minutes, press
simultaneously for 5 seconds to start forced
defrosting.
The lamp flashes and defrost starts,
when the lamp stops flashing defrosting stops.
The interval between forced defrosts must be more
than 30 minutes.
and
for initial heating.
for 3 seconds,
and
23