Joycare NANNOLO JC-1247 Mode D'emploi page 8

GB
• Dry the metal parts to prevent the formation of rust. • Check the cot periodically for signs of damage
or wear. Should any part be damaged, do not use the product.
• The cover of the cot is not removable: Clean with a damp sponge and neutral detergent.
Do not wash Do not tumble dry Do not dry clean
Do not iron Do not bleach
INSTRUCTIONS FOR USE
COT COMPONENTS
a) Cot (see diagram 5)
b) Mattress (see diagram 5)
c) Bag/rucksack (see diagram 6)
HOW TO OPEN THE PRODUCT
1. Remove the cot from the bag and place it in a vertical position, with the corners upwards. Unfasten
the Velcro straps (fig. 1) and re¬move the mattress from the cot.
2. Hold the two short sides, located opposite to each other, and pull them externally and in an upward
direction, until they are locked into position (Fig. 2). A "click" will be heard, indicating that the cot is
opened correctly.
3. Repeat the above operation on the other two sides (Fig. 3).
WARNING: To lock the side joints more easily, keep the cot's feet as close together as possible.
4. Apply a little downward pressure with your hands in the central section on the sides to make sure
the four sides are firmly locked in place; now apply pressure to the centre of the bottom of the cot until
you hear it click, locking into place .
5. Place the mattress on the bottom of the cot (diagram 5).
The length of the fabric strap can be adjusted.
WARNING: When the child is lying in the cot, always ensure that the zips are completely fastened.
HOW TO CLOSE THE COT
7. Remove the mattress (Fig5 ). Pull the handle in the centre of the base upwards, to release the locking
mecha¬nism
8. Holding always raised the central handle with one hand, push with the other hand the buttons
located externally on the central joints of the long superior sides (diagram 9). Raise them slightly to
unlock the safety device, and fold them in a downward direction.
9. Repeat the above operation with the short inferior sides.
WARNING: if during the folding operation, the long inferior sides should accidentally get blocked in
open position, it is necessary to manually un¬block the long inferior sides.
WARNING: During this operation, ensure that the baby is at a proper distance and pay attention to the
mobile parts between the tubes.
When this operation is finished, put the cot in a vertical position raising it by the central handle.
10. Pull the central handle in an upward direction to fold the four legs (Fig. 7).
11. Replace the Playard Cot Bed in its storage bag (Fig.8).
Specifications and designs are based on the last information available at the time of printing and subject to change
without notice.
8