Tips; Cleaning And Maintenance - Inventum JB010 Mode D'emploi

Attention:
• Do not place hot food in the appliance.
• You should never place hazardous, highly flammable or explosive substances such as alcohol, acetone or petrol
in the appliance, because there will be a hazard of explosion.
• Carefully package meat and fish to prevent unpleasant smells.
• Leave sufficient space between the different foods, to allow the air to circulate properly.
• Do not place food against the rear wall of the appliance. The shelves have a stopper to prevent this.
• Do not leave the doors open for longer than necessary.
6

tips

• A high ambient temperature will have a negative effect on the energy consumption. Direct sunlight and other heat
sources near the appliance also have a negative effect.
• Keep ventilation holes free. Covered and dirty holes cause a high energy consumption. Ensure sufficient space around
the refrigerator, so that a proper ventilation and air flow around the appliance is possible.
• Do not open the doors of the appliance more often than necessary and leave the doors open as briefly as possible.
• The distance between the shelves and the rear wall ensures a free air circulation. Do not place food against the rear wall.
• Set the thermostat to a lower setting if circumstances allow.
• Allow cooked food that you want to store in the appliance to cool down to room temperature before placing
it in the appliance.
• A door rubber that does not close properly could increase the power consumption. Therefore, have it replaced
by a skilled person in time.
• If the instructions are not observed, this could lead to a higher power consumption.
7

cleaning and maintenance

Before cleaning the appliance, switch it off by removing the plug from the socket.
Clean the interior of the appliance. Use warm soapy water with, for instance, washing-up liquid, all-purpose cleaner
or soda in order to prevent nasty smells. Wipe the inside of the appliance after cleaning with clean water and properly
wipe everything dry. Leave the appliance to dry for 1 to 2 hours.
The shelves, drawers and door compartments can be removed from the appliance easily and washed by hand.
These components may never be cleaned in the dishwasher.
Clean the outside of the appliance and the door rubbers with a soft damp cloth.
DEFROSTING
The freezer section of this appliance is free from frost - no-frost. If used correctly, no ice will be formed.
If an ice layer is created after all, defrost the freezer section when the ice layer has reached a thickness of 3 mm. Remove all
products from the freezer section. Store the frozen products on a cool location, packaged in newspapers and blankets.
Remove the plug from the socket and keep the door of the cooler section closed while defrosting the freezer section.
Defrost the freezer section Defrosting can be accelerated by placing a tray with hot water in the freezer section. Do not use
sharp metal objects to scrape the freezer section clean, use a plastic ice scraper.
Clean and dry the freezer section. Insert the plug in the socket and set the thermostat to the required setting.
Place the frozen products back in the freezer section once it has reached the required temperature.
Warning Never remove ice with sharp objects, defrosting sprays, a hair dryer, a heater or something similar.
This could lead to unsafe situations and cause irreparable damage to the appliance
REPLACING THE LED LAMP
This appliance has been provided with a LED lamp. This lamp lasts for a longer period of time. When the LED lamp
in the appliance is broken, you are not able to replace it yourself. Contact the Inventum service department.
24
• English