Using The Single Serve Bottle - CASO DESIGN NOVEA B4 Mode D'emploi

4. Repeat procedure until contents reach desired consistency.
5. To add food or fruit to the jar, remove the measuring cup in
the middle of the lid. Add the food or fruit through the hole in
the middle of the lid and then replace the measuring cup on
lid (see fig. 5)
6. Press again if you want to go back to normal state.
Please note
► button can be held longer than 2 seconds if needed.
► The Pulse mode cannot be combined with the Single Serve
function!
Warning
► Do not touch blades. Always turn blender off and wait until blades have stopped rotating
before moving jar or lid.
► NEVER start up the blender without the lid and measuring cup. The speed of the blades
will throw contents high up in the jar, and without the lid could spill out.
► For your own safety:
Never operate the device without the original lid that is part of delivery scope. In addition
do never put your hand into the blender jar during operation.

14.2.1 Using the Single Serve bottle

Warning
Personal and property damages can occur during commissioning of the accessory!
Observe the following safety notices to avoid such dangers:
► Only put the Single Serve Bottle onto the blender if it is completely
assembled! Do not put the blade assembly onto the base on its own!
1. Insert the plug into an appropriate wall socket.
2. Fill the bottle with desired food and secure the blade assembly lid
onto the bottle as shown in Fig. 6.
3. Turn the bottle upside down and place it onto the motor base,
aligning the tabs on the bottle with the motor base.
4. Turn the bottle clockwise.
5. Press , the buttons
with 0:00.
6. Press and hold
blending.
7. Blending will stop after 1 minute, even if
countdown is shown in the display.
8. Counter returns to 0:00 and illumination starts flashing.
9. Press momentarily for pulsed operation.
Caso Blender NOVEA B4
and will flash. LED display will flash
to start blending. Release the button to stop
is still pressed. The
30