Switching On And Off; Cleaning And Maintenance; Technical Data; Noise And Vibration - Work Men WMBD1101BM Traduction Des Instructions D'origine

Only set the hammer
functions (2) and (3) when the
machine is switched off.
Hammer/ drill mode:
Drill in masonry, concrete and natural stone.
Don't use the hammer drill function for ceramic
tile or others material can not withstand impact
energy.
Hammer mode:
Drill in masonry, concrete and natural stone.
Drilling mode:
Drilling in wood, synthetic materials and metal.
When hammer drilling you
will require a low pressure.
Too much pressure will place
unnecessary load on the
motor. Check the drill bits
regularly. Re-sharpen or
replace blunt drill bits.
INSTRUCTIONS FOR USE
_ Before inserting a drill bit or chisel, always grease
the shaft.
_ When a cold machine is to be used for chiselling,
first let it run idle for a few minutes to allow the grease
to spread in the mechanism.
_ If the machine does not hammer properly,
first check if the switch is in the hammering position
and if the drill bit or chisel is correctly fitted.
_ Vibrations may cause slight leakage of oil
through the joints of the housing. In this
case, you need to tighten the bolts.

SWITCHING ON AND OFF

To switch on the machine, press the on/off switch (1).
To switch off the machine, release the on/off switch.

CLEANING AND MAINTENANCE

Attention! Before
performing any work on
the equipment, pull the
Service
§ Only qualified specialist personnel and original
replacement parts should be used for repairs. This will
ensure that your device remains safe.
Cleaning
§ Regularly clean the machine housing with a soft
cloth, preferably after each use. Keep the
ventilation slots free from dust and dirt. If the dirt does
not come off use a soft cloth
power plug.
moistened with soapy water. Never use solvents such
as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
Lubrication
After approximately 50 hours the machine must be
lubricated.
Open the cover of the lubrication point (8).
Apply an appropriate amount of grease to the
mechanism.
Close the cover.
Checking and replacing the carbon brushes
The carbon brushes must be checked on a regular
basis.
_ Remove the carbon brush holders and clean the
carbon brushes.
_ In case of wear, replace both carbon brushes at the
same time.
_ Mount the carbon brush holders.
_ After mounting new carbon brushes, let
the machine run at no load for 15 minutes.
Use only the correct type of

TECHNICAL DATA

Mains voltage V
Mains frequency Hz
Power input W
Joules
SDS+ Chuck mm
-1
Speed min
No. of strokes, under load min
Drilling capacity
in steel/wood/masonry mm
Lubricant ball-bearing grease
Weight kg

NOISE AND VIBRATION

Noise emission values measured according to
relevant standard.
Acoustic pressure level
LpA 94.9 dB(A) K=3 dB(A)
Acoustic power level
LwA 105.9 dB(A) K=3 dB(A)
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
Weighted root mean square acceleration according to
relevant standard. :
Ah cheq 17.733 m / s ²
ah HD 20.937 m / s ²
carbon brushes.
230-240
50
1100
3.2
32
730
-1
4000
13/40/32
5.9
ATTENTION !
must be worn.
K = 1.5 m / s ²
K = 1.5 m / s
16