VONROC S AG501DC Traduction De La Notice Originale page 12

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the char-
ger plug from the outlet and remove the battery
from the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Assembling the protection guard (Fig. E and F)
1. Place the machine on a table with the spindle
(7) facing upwards.
2. Place the protection guard (3) over the machine
head as shown in Figure E making sure the
ridges on the protection guard fall into the
notches of the machine head.
3. Turn the protection guard counter clockwise as
shown in Figure F and clench the release lever
for protection guard (2).
4. You can adjust the position of the protection
guard by releasing the lever (2), adjust the
guard to the desired position and clench the
lever to lock it.
Mounting and removing the wheel disc (Fig. D)
Do not use the machine without the guard.
Only use sharp and undamaged wheel
discs.
• Always use suitable wheel disc for this machine
with diameter Ø 115 mm and a bore from
22.2 mm the thickness of the wheel disc should
be 6 mm for wheel disc for grinding and 3 mm
for wheel disc for cutting, the mounting wheel
disc may not touch the safety guard.
Mounting
1. Place the machine on a table with the protecti-
on guard (3) facing upwards.
2. Mount the flange (9) onto the spindle (7).
3. Place the wheel disc (10) onto the spindle (7).
4. Keep the spindle lock button (1) pressed and
firmly tighten the clamping nut (11) onto the
spindle (7) by using the spanner (12).
12
Removing
1. Place the machine on a table with the protecti-
on guard (3) facing upwards.
2. Keep the spindle lock button (1) pressed and
loosen the clamping nut (11) using the spanner
(12).
3. Remove the wheel disc (10) from the spindle (7).
4. Keep the spindle lock button (1) pressed and
firmly tighten the clamping nut (11) using the
spanner (12).
Mounting the side handle (Fig. A and G)
• The side handle (8) can be screwed into one of
the three side handle connection points (6).
4. OPERATION
Make sure that the work piece is properly
supported or fixed.
Switching on and off (Fig. B)
• To switch on the machine in continuous mode,
slide the on/off switch (5) to the right and slide
the on/off switch (5) in the direction of the
grinding disc (fig. B1).
• To switch off the machine, press the lower part
of the on/off switch (5) (fig. B2). Hold the ma-
chine away from the work piece when turning
it on and off because the wheel disc could
damage the work piece.
• Clamp the work piece firmly or use another me-
thod to ensure that it cannot move while working.
• Check the discs regularly. Worn wheel discs
have a negative effect on the machine's effici-
ency. Change to a new wheel disc in good time.
Deburring (Fig. H)
An angle of inclination of 30
the best results when deburring. Move the
machine back and forth using light
pressure. This will prevent the work piece
from discolouring or becoming too hot and
will avoid making groves.
Never use abrasive cutting discs for
deburring work!
Cutting (Fig. I)
For cutting, a special protection guard must
be used (not included).
to 40
will give
0
0
WWW.VONROC.COM

Publicité

Table des Matières
loading

Table des Matières