Care And Cleaning - Varan SPT-15103 Manuel D'utilisation

WARNING: Be aware that air tools may hold residual pressure after use. Always bleed air pressure from the tool after
shutting off air supply.
Accessories
Accessories for this tool including Face Masks and Safety Goggles is available from your stockist. Spare parts can be
obtained from your dealer

CARE AND CLEANING

Maintenance
WARNING: Always disconnect from the air supply and depressurise before cleaning or carrying out any maintenance.
Cleaning
Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and shorten the machine's
service life. Clean the body of your machine with a soft brush, or dry cloth
IMPORTANT: There is very little that can go wrong with your air tool and it should be noted that when an air tool fails
to work it is generally because the internal workings have corroded due to dirty, wet air and failure to follow the
instructions given below.
Daily maintenance procedure: Disconnect from the air supply, pour the equivalent of a tablespoon of oil into the air
intake. Operate the machine at low speed to thoroughly lubricate all internal workings.
If the machine is in constant use or used for long periods at a time, a combined filter/ lubricator must be fitted. There
must be an air filter fitted at all times
Use air tool oil only. DO NOT UNDER ANY CIRCUMSTANCES USE NORMAL ENGINE OIL
Failure to comply with the operating and maintenance instructions may invalidate the guarantee
Storage
Store this tool carefully in a secure, dry place out of the reach of children
Disposal
As with other power tools, air tools should not be disposed of with household waste
Air tools may contain traces of tool oil and other lubricants and so must be recycled accordingly
Contact your local waste disposal authority for information on the correct way to dispose of power tools
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg T: 00352/26908036 – F: 00352/26908040
SPT-15103
SPT-15105