Varan SPT-15103 Manuel D'utilisation page 23

Adjusting the guard
Note: Inspect the guard before every use, and replace if damaged.
WARNING: This tool must NEVER be operated without the guard in place and correctly positioned.
• Depending in the application and work angle, the position of the guard must be adjusted, to
always be located between the disc and the user:
Use the Hex Key (6) to loosen the guard clamping screw
1.
Adjust guard position and re-tighten screw
2.
WARNING: DO NOT overtighten. Overtightening may damage the guard.
OPERATION
Rotating cut-off tool, powered by compressed air from a compressor, for cutting of metal (mainly thin sheet metal,
nuts/bolts, car bodywork etc.).
WARNING: DO NOT switch the machine on/off when the disc is in contact with the workpiece. Always allow the
motor to reach its full speed before applying load, and to stop completely before placing the grinder down. Always
hold the machine securely, using both hands, on the handles provided.
Note: Do not apply too much pressure to the machine whilst grinding. Excessive pressure does not result in more
effective removal of material, but will cause premature wear of the grinding disc and increase wear and tear on the
machine.
WARNING: This is a cutting device only. DO NOT attempt to use it for sideways grinding, as axial force will cause the
cutting disc to shatter.
Hold the tool by its Handle (1) and turn it so the open side of the Guard (2) is facing away from you. Your thumb
1.
should wrap around the Handle (1) and your fingers should
Disengage the Safety Catch (8) and gently squeeze the trigger towards the handle
2.
The Cutting Disc (5) will begin to spin. Squeeze the trigger further to increase the speed, slightly release to decrease
3.
the speed
With the disc spinning at the required speed, slowly move the disc towards the workpiece to be cut and gently
4.
engage the material
WARNING: When the disc begins to cut, it will force the tool to move sideways. Make sure you have a firm grip on
the tool and are ready to counteract this.
As the disc begins to cut, take note of the direction of the waste material being ejected. It should be going away
5.
from you, and not towards any person or object to which it may cause damage
To stop the tool, remove the disc from the workpiece, fully release the trigger and allow the safety catch to re-
6.
engage
Note: DO NOT allow the tool to run in 'idle rotation' for an extended period of time. This will shorten its life.
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
Tighten
Loosen
sit on the Speed Control Trigger (9)
T: 00352/26908036 – F: 00352/26908040
Fig. I
Spindle (3)
Tighten
Loosen
SPT-15103
SPT-15105