Soba XC510 Mode D'emploi page 5

XC510 AIR CONDITIONER/DEHUMIDIFIER
Wall Installation
1. Waste-air outlet
2. Connector
3. Waste-air hose
4. Wall adaptor
Note: The Wall Adaptor is mounted on the inside wall.
1. Drill a 11,4 cm/4 1⁄2 inch diameter hole in the wall at least 40,6 cm/16 inches above
floor level. As a safety precaution, ask a professional (e.g. mason, carpenter or
electrician) to choose the position for the hole to ensure no supporting elements
or electrical wires are damaged.
2. Hold the wall adaptor against the 11,4 cm/4 1⁄2 inch hole and mark the position
of the screw holes.
3. Remove the wall adaptor and drill four 0,5 cm/3/16 inch diameter holes at these
marks.
4. Insert a 15,2 cm/6 inch long piece of 10,1 cm/4 inch PVC pipe (not included) to
take the flow of waste air.
Note: To prevent birds, animals or insects from nesting in the PVC pipe, cover over
the outer end of the pipe with a fine mesh screen. If necessary protect against the
elements.
5. Mount the wall adaptor on the wall with four screws.
6. Twist the waste-air hose clockwise into the wall adaptor until it fits firmly.
7. When not in use, unscrew the waste-air hose from the wall adaptor and place the
wall adaptor cap over the hole.
Note: The manufacturers provide instructions for interior wall mounting only. Exterior
wall mounting is at the customer's discretion.
Note: This unit can also be vented through the ceiling. Please consult with an air
conditioning professional for ceiling venting installation.
The waste-air hose can be pulled out, if necessary, to a maximum of 1,5 m/5 feet.
If you wish to extend it, use a conventional 1,5 m/5 foot, 10,1 cm/4 inch diameter
PVC pipe. First cut the waste-air hose in half and insert the PVC pipe between the two
pieces of the hose and fix with duct tape. The overall length must not exceed 3 m/10
feet. Insulating tape can also be used to join the pipe and hose. Do not use aluminium
pipes to extend the waste-air hose.
2
1
5
INSTRUCTIONS
3
4