Soba XC510 Mode D'emploi page 4

XC510 AIR CONDITIONER/DEHUMIDIFIER
WASTE AIR KIT INSTALLATION
Window Installation
1. Waste-air outlet
2. Connectors (2)
3. Waste-air hose
4. Connector/panel adaptor
5. Adjustable window panel (optional)
The adjustable Window Panel Kit (optional) adapts from 72 to 108 cm (28.4" to
42.5") to fit various window sizes.
2
1
Note: The waste-air hose need not be installed for dehumidifying mode.
1. Remove the Window Panel, the two connectors, the waste-air hose and the
connector/panel adaptor from the accessories box.
2. Measure the window where the unit is to be installed and adjust the window
panel to fit into the window. If the window is either too wide or too tall, cut some
pieces of polystyrene foam to fit round the edges of the window panel to seal any
spaces.
3. Mount the element that connects the end of the hose with the Window Panel as
shown in the diagram.
4. Secure the two connectors at both ends of the waste-air hose by pulling the ends
of the waste-air hose out gently, then screw the two connectors into either end
of the hose.
5. Insert one end into the waste-air outlet at the back of the unit. Then insert the
other end into the connector/panel adaptor.
3 4 5
Horizontal
4
INSTRUCTIONS
Vertical