Brinno PHV MAC Mode D'emploi page 8

Installation
1. Insert PeepHole lens in the outside of the
door.
2. For the 12mm Peephole
(North American users most likely.)
Insert the Peephole barrel through the
Washer and Base Flange and insert both into
the hole on the inside of the door. Tighten
the PeepHole Barrel with your fingers.
2. For the 14mm Peephole
Insert the PeepHole barrel through Base
Flange and insert both into the hole on the
inside of the door. Tighten the PeepHole
Barrel with your fingers.
3. When the barrel is snug, rotate the Base
Flange until the TOP icon is at 12 o'clock
(vertical).
4. Use the Tightening Tool included to
tighten the PeepHole barrel.
PHV MAC- EN
08
1
PHV MAC12
2
PHV MAC14
2
3
4