Accessories; Maintenance And Cleaning; Technical Data - Batavia MAXXPACK BT-CID001 7062505 Mode D'emploi

English
WARNING: If the power tool gets exces-
sively hot in use, stop using the tool immedi-
ately and allow to cool before continuing
work. The cooling period can be reduced by
operating the drill at maximum speed with
no load. Always make sure the Motor Vents
(3) are not blocked and do not allow dust to
enter the body of the tool through the Motor
Vents; dust, especially metallic dust, may
damage or destroy the tool.

8. Accessories

Use only accessories with an allowable
speed matching at least the highest no-load
speed of the tool.

9. Maintenance and Cleaning

WARNING: Always disconnect from the
mains power supply, before carrying out any
maintenance/ cleaning of the charger.
Remove the battery before carrying out any
maintenance/cleaning of the tool.
Maintenance
9.1
There are no inner parts of the tool which
need maintenance.
Cleaning
9.2
• Keep safety devices, ventilation open-
ings and the motor housing as free as
possible from dirt and dust. Rub the
electric power tool with a clean cloth or
blow over it with low pressure com-
pressed air.
• We recommend that you clean your
electric power tool immediately after
each use.
• Clean the electric power tool regularly
with a damp cloth and somewhat soft
soap.
Do not use any cleaning or solvent materi-
als; these can attack the device's plastic
components. Make sure that no water can
get inside the electric power tool.
6

10. Technical data

Speed . . . . . . . . . . . . . . 0 – 2200 min
Impacts per minute . . . . . . 0 – 3000 min
Bit holder . . . . . . . 1/4" (6.35 mm) hex bits
Max. torque. . . . . . . . . . . . . . . 150 Nm
Dimensions. . . . . . . . . . 17 × 10 × 21 cm
Weight. . . . . . . . . . . . . . . . . . 1.12 kg
Sound Pressure Level L
Uncertainty K . . . . . . . . . . . . . . . 3 dB
pA
Sound Power Level L
Uncertainty K . . . . . . . . . . . . . . 3 dB
WA
Hand Arm Vibration . . . . . . . . . 12.8 m/s
Uncertainty K. . . . . . . . . . . . . . 1.5m/s
11. Disposal
Do not dispose of electric power
tools with domestic refuse.
The electric power tool is shipped in pack-
aging to reduce transport damage. This
packaging is a raw material and as such can
either be reused or can be fed back into the
raw material cycle. The electric power tool
and its accessories are made from various
materials such as metals and plastics. Take
defective components to a special refuse
collection point. Ask about these at your
specialist shop or local council. The product
and the user manual may be subject to
changes. Technical data may be changed
without prior notice.
Batteries
11.1
Think of the environment when disposing of
batteries. Contact your local authorities to
find out where your nearest disposal area is.
Do not dispose of batteries with domestic
refuse.
Do not dispose of by burning, risk of
explosion.
. . . . .106 dB(A)
pA
. . . . . . . 117 dB(A)
WA
-1
-1
2
2