Warning Label Identification; Lubrication - Ingersoll Rand 311A Mode D'emploi

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.

LUBRICATION

Ingersoll- - Rand No. 50
Always use of an air line lubricator with these tools.
We recommend the following Filter- - Lubricator- - Regulator
Unit:
For International- - No. C28- - C4- - FKG0
For USA- - No. C28- - 04- - FKG0- - 28
Before starting the Tool and after each two or three
hours of operation, unless the air line lubricator is used,
detach the air hose and inject 0.5 - - 1.0 cc of
Ingersoll- - Rand No. 50 Oil into the air inlet.
Model
311A
Tested in accordance with PNEUROP PN8NTC1.2
H
♦ Tested in accordance with ISO8662- - 1 sanding on steel workpiece

WARNING LABEL IDENTIFICATION

90 psig
(6.2bar/620kPa)
PLACING TOOL IN SERVICE
SPECIFICATIONS
Free Speed Pad Diameter
rpm
12,000
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
HSound Level
in (mm) Pressure
6 (152) 87.3
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
FILTER
COMPRESSOR
(Dwg. TPD905- -1)
♦Vibrations
dB (A) Level
Power m/s
100.3 6.3
2