Installation; Mounting Of Sensors In The Oil/Petrol Separator - Pepperl+Fuchs LAL-SRW Manuel

WARNING DEVICE

Installation

3 Installation
3.1

Mounting of sensors in the oil/petrol separator

EN
Read the chapter on Safety and, in particular, the section on Installation and commissioning
(see chapter 1.7) before installing the sensor. Do not remove the identification plate.
Warning!
Risk of short circuit
Injuries and damage to the device are possible when working with live parts.
•
•
During installation, observe the instructions of the oil/petrol separator manufacturer. Always
ensure that the sensor suspension device remains constantly at the correct height. If possible,
ensure that the suspension device is mounted in a location that can be reached from the
separator access shaft so that it is possible to raise the sensor during separator emptying
(disposal) or maintenance of the oil/petrol separator.
Note!
Further information on the installation of the sensor is available in the manuals of the sensors.
10 - EN
Before working on the device, always disconnect the supply voltage.
Connect the device to the supply voltage only after completion of the work.