Front Panel Controls - ADB MULTIPRO-MK2 Manuel D'instructions

Lighting Technologies

Front Panel Controls

Input Protocol Selection
The protocol used by each of the two inputs is shown by the two bands of LED's on
the left side of the front panel.
The six possible options are cycled through by repeatedly pressing the push button
to the right of the LED's. The seventh key press will switch off all the LED's.
This option disables the relevant input.
Input Offset Address
The Input Offset Address defines the output channel number at which input data will
start.
When this control is set to '001', input data starts at the first output channel.
The maximum Input Offset Address is dependent upon the selected output protocol
as shown below:
Protocol Maximum Input Offset Address
DMX512 512
AMX192 192
D54 384
AVAB 256
S20 480
The settings of the two Input Offset Address switches defines how the two inputs are
merged to the output. If the addresses are set such that the two inputs overlap, the
output is formed from a highest takes precedence merge.
If the inputs do not overlap, the two inputs are concatenated to form the output.
Example of HTP Merged Inputs
DMX 512 output
512 channels
DMX 512 output
512 channels
MULTIPRO - MK2
Input A
Offset = 001
Input B
Offset = 001
Output is HTP
Merge of
both inputs
Page 5
Rev. : 002