Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Instruction Manual
Lighting Technologies
Delivery - Unpacking
Upon delivery of your equipment, open the packaging carefully and examine the
material.
If you observe any damage, contact the shipping company immediately, and have
your complaint duly recorded. You may rest assured that your equipment left the
factory in perfect condition.
Check whether what you have received is in conformity with the delivery notice, and
whether the notice is in conformity with your order.
In the event of any error, contact your shipper immediately to clarify the situation and
receive full satisfaction.
If you find nothing wrong, replace the material in the packing and store it in a warm
place, away from dust and humidity, while awaiting final installation.
Never leave the material on the worksite under any circumstance.
Generalities - Safety
The equipment is built in accordance with European safety standards and requires
imperatively a safety earth connection in compliance with local regulations.
To prevent any risk of electric shock, do not remove any cover or part of the
enclosure.
Access to internal parts is not required for normal operation.
Refer servicing to skilled and trained service personnel exclusively.
Disconnect from the power supply prior to opening for inspection or service.
WARNING ! LETHAL VOLTAGES ARE PRESENT INSIDE
Connection to an inappropriate power source may irreversibly damage the
equipment, it is the user's responsibility to use the equipment for its intended
purpose and to check the equipment connected to it.
To obtain full benefits of the safety measures, the equipment shall be installed and
serviced by skilled and trained personnel exclusively.
Don't make any modification to the equipment.
ADB shall not accept any liability for material damages or injuries which may result
from unauthorised modifications.
Important Notice for Power Cables
Power supply cables and connectors are an important part of your equipment and
contribute to its safety.
• always use an isolator or main circuit-breaker, or main fuses to interrupt the link;
never pull on the cable
• do not damage the cable nor the connectors in any way, check them at each
installation or at regular intervals in a permanent installation
• do not tie together power supply cables and signal cables
MULTIPRO - MK2
Page
3
Rev. : 002
Publicité
Table des Matières
