Geemarc CL7160 Loop Mode D'emploi page 10

OPERATION
OPERATION
1. Make sure that the transmitter/charger is correctly
connected to the mains supply using the adapter
supplied.
2. Put on the headset such that the front(silkscreened)
part of the headset is facing the transmitter.
3. Turn on the headset using the ON/ OFF/ VOLUME
4. Use the tone control wheel to adjust the tone
frequency to suit your needs.
5. If you wish to listen to TV while not wearing a hearing
aid you may connect standard headphones which
have a 3.5mm plug by inserting the 3.5mm plug into
the 3.5mm audio output socket in the headset.
Use the included balance control tool ( ) to adjust the
volume balance between the left and right ears. This
control is on the headset
6. When you are finished using the system carefully
place the headset in the charging cradle making sure
that it fits snugly. Check that the charging light turns
on.
NOTE: The induction neck loop has an "easy-break" plug and
socket (refer to the sketch on page 4). Should the loop become
tangled or you are having difficulty removing the loop from around
your neck simply pull on the loop near the easy-break and it will
come free easily.
control and adjust the volume.
.
9