Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation & Operation (Continued)
3. Tilt the head to the desired angle (15°, 30°, or 45°). The holes in the two center
brackets should align based on which angle is trying to be achieved. Lock the
head in place using the included Philips head screw (Figure 3). It is
recommended to use a long Philips screw driver (at least 8" from the base)
and enter from the side of the fixture when securing the screw.
4. Re-tighten the adjustment screws on the side of the fixture.
5. Use a flat head screwdriver to remove the two rubber plugs from the
sides of the driver box (Figure 4).
6. Remove the screws from the sides of the driver box using an M4 hex key (Figure 5).
7. Use a flat head screwdriver to unscrew the cap from the back of the driver box mounting plate (Figure 6).
8. Separate the back mounting plate from the driver box. A flat head screwdriver may be needed to remove the
back mounting plate from the driver box (Figure 7).
9. Drill mounting holes in the mounting plate following the template as shown. Drill through the raised hole locations
that correspond to the mounting points on the intended junction box (Figure 8):
Ø 2.774"
[70.46]
Ø 3.500"
[88.9]
Publicité
Table des Matières
