Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
General Wiring Diagram
CAUTION: Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
0-10V Dimmable Wiring:
HOT
NEUTRAL
GROUND
(+) DIM V+
(-) DIM V-
1.) Connect the black fixture wire to the HOT LINE supply wire.
2.) Connect the white fixture wire to the NEUTRAL supply wire.
3.) Connect the green fixture wire to supply ground wire.
4.) Cap the YELLOW wire.
5.) Connect the purple fixture wire to the (V+) DIM wire.
6.) Connect the gray fixture wire to the (V-) DIM wire.
Installation & Operation
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the fuse box.
Turning the power off using the light switch is not sufficient to prevent electrical shock.
1. The fixture should be set at a full cutoff 0° angle. If this angle is desired, skip to step 5. If another angle is
desired (either 15°, 30°, or 45°) remove the two front hex screws (Figure 1).
2. Loosen the adjustment screws (Figure 2) on the side of the fixture.
Front Hex Screws
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
BLACK
WHITE
GREEN
Light
Fixture
YELLOW
PURPLE
GRAY
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
Head Adjustment
Screw
Publicité
Table des Matières
