Filling The Reservoir; Getting Started - Waterpik WP-450 Mode D'emploi

Important! Turn Water Flosser off and charge for 24
hours before first use. Plug the cord into any standard electrical
outlet. Make sure you push the switch into the OFF (0) position before
charging. The unit will not charge if the switch is in the ON (I) position. See
"Cleaning and Troubleshooting Your Waterpik
on how to look after your battery. The Waterpik
charged for up to 2 weeks depending on use.

Filling the Reservoir

Disconnect charging cord from the unit prior to filling the reservoir and product
use. Lift flip top on reservoir and fill the reservoir with lukewarm water.
Water Flosser" for guidance
®
Water Flosser will stay
®
Inserting and Removing Tips
Insert tip into the center of the knob at the top of the
Water Flosser handle. The colored ring will be flush
with the end of the knob if the tip is correctly locked
into place.
To remove the tip from the handle, press the tip eject
button and pull tip from the handle.
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water Flosser
by simply sliding the pressure switch on the handle.

GETTING STARTED

Tip
Eject
Button
Pressure
Setting
7