Section 1. Important Safety Instructions - Zodiac Pool Systems Jandy AquaPure Ei Série Mode D'emploi

Section 1. Important Safety Instructions
READ AND FOLLOW ALL INSTRUCTIONS
All electrical work must be performed by a licensed electrician and conform to all national, state, and local codes.
When installing and using this electrical equipment, basic safety precautions should always be followed, including the
following:
EQUIPMENT UNDER PRESSURE: Always turn pump off prior to installing or servicing the power pack, pod,
or cell. Your pump/fi lter system is operated under pressure and the pressure must be released before you begin
work. Please see your pump/fi lter owner's manual for further instructions.
To reduce the risk of electric shock, fi re or injury, service should only be attempted by a qualifi ed pool service professional.
Jandy ® AquaPure ® Ei TM
Contrary use could affect performance, void warranty, and may result in property damage, serious injury, or death.
• Operating a chlorine generator without water fl owing through the cell may cause a build up of fl ammable gases,
resulting in fi re or explosion.
• Keep equipment out of reach of children.
• Do not use if supply cord is damaged.
• A damaged supply cord should only be replaced by the manufacturer, service agent or electrician.
• When installing and using this electrical equipment, always follow basic safety precautions.
• Before performing installation, disconnect all power.
• Connect to a circuit that is protected by a ground fault circuit interrupter (GFCI).
• Do not install within an outer enclosure or beneath the skirt of a hot tub or spa.
Installation must be done in accordance with the National Electrical Code ("NEC" or NFPA-70) in the US, and/or any
other local and national installation codes.
RISK OF ELECTRIC SHOCK, FIRE, PERSONAL INJURY, OR DEATH. Connect only to a branch circuit that is
protected by a ground-fault circuit-interrupter (GFCI). Contact a qualifi ed electrician if you cannot verify that the circuit
is protected by a GFCI. Make sure such a GFCI should be provided by the installer and should be tested on a routine
basis. To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button. Power should
be restored. If the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI interrupts power to the pump
without the test button being pushed, a ground current is fl owing, indicating the possibility of electrical shock. Do not
use the device. Disconnect the device and have the problem corrected by a qualifi ed service representative before
using.
It is required that the water fl ow pod is installed in the same piping as the electrolytic cell, without any valves or divert-
ers between them (see Section 3.2, Figure 3).
The fl ow pod must be mounted as in Section 3.2, Figure 3.
chlorine generating devices are designed for domestic (residential) swimming pool use only.
WARNING
WARNING
WARNING
WARNING
Page 5