ECG RS 200 Mode D'emploi page 25

HAND MIXER
IMPORTANT SAFETY MEASURES
Before putting an electric product into operation you should adhere to
basic provisions, including the following:
1. Read all instructions.
2. Before use check that the voltage in your power socked corresponds
to the voltage on the label located on the underside of the product.
The outlet must be installed in accordance with applicable electrical
codes according to EN.
3. Do not use the product if the power cord is damaged, if it is
malfunctioning, if you have dropped it or in any other way damaged
it. Take the product to the nearest authorised service centre, where it
will be inspected, and electrical or mechanical parts will be repaired
or modified.
4. If you are not using the product, before installation or disassembly
of parts and before cleaning, disconnect it from the power socket by
pulling out the power plug!
5. Do not leave the cord hanging over a table edge or shelf and don't
place it on a hot surface.
6. Do not place the cable or mixer itself in water, you can be exposed
to danger of injury by electric shock.
7. Avoid contact with moving parts. Do not touch the beaters during
operation with hands, clothing, tea towels or other kitchen utensils;
reduce the risk of personal injury and/or damage to the mixer.
8. Remove all the accessories before washing (beaters, dough hooks).
Wipe the drive unit with damp cloth only and then wipe dry.
9. Turn off the product before changing accessories or coming near
parts that move during operation.
10. Do not use the product for purposes other than those here specified.
11. Do not use outdoors.
12. Store this user's guide.
13. This appliance can be used by children ages 8 and older and by the
physically and mentally impaired or by individuals with insufficient
experience and knowledge, if supervised or trained to use the
appliance in a safe manner and understand the risks involved with
GB
25