Amplicomms TCL 350 Mode D'emploi page 19

Installation
Attention: Only use the power adapter plug contained in
the material supplied since other power adapter plugs
could damage the product. Ensure access to the power
adapter plug is not obstructed by furniture or such. The
socket-outlet shall be installed near the equipment and
shall be easily accessible.
Back-up batteries
With the back-up batteries (2 x AAA) installed, the clock will
keep the time and alarm settings in the event of a power cut or
the DC adaptor being unplugged. During a power cut, the clock
will not display the time, and the alarm function will not work.
If no batteries are installed and a power cut occurs, then the
clock will lose its time and alarm setting. This is important as if
there is a power cut in the night then the alarm will not be set
correctly to wake you up in the morning at the required time.
Check the battery condition after one year, replace old
batteries. A leaking battery can destroy your clock.
For replacing the battery, place your unit face down on a flat
surface. Slide and remove the battery cover at the bottom of
your unit. Insert two new AAA batteries as shown into the
battery compartment (observe the correct polarity!). Replace the
battery cover.
CAUTION
• RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE.
Helpline UK 0844 800 6503
16
(See chapter "Helpline" for costs and hours of operation)