Unold MINI BLACK Notice D'utilisation page 22

1. If the transparent locking cover is attached,
pull it off of the appliance.
2. Prepare your hair as described in the chapter
„Before first use".
3. Attention: your hair should be completely dry
before straightening. Straightening your hair
when it is still damp will damage your hair.
Therefore you should dry your hair well using a
hair dryer, if necessary.
4. Connect the plug to a wall socket (110–
240 V~, 50 Hz)
5. Separate the combed hair into strands no more
than 5 cm wide. If necessary, separate the
strands using hair clips.
6. Switch the appliance on pushing the button
EIN/AUS [ON/OFF]. The indicator light lights
up red.
7. Heat the appliance up for approx. 90 seconds
in order to achieve the best styling result.
8. Open the appliance and place a small section
of hair between the straightening plates close
to the root.
9. Shut the appliance.
10. Now work your way down slowly and evenly
to the ends of your hair. Maintain the appli-
ance firmly closed during this process. Never
work the same part for more than two sec-
onds to avoid damaging your hair. For an even
and straight look, work your way straight down
keeping the appliance close to your head.
Working your way through slightly lifting the
appliance will give your hair more volume.
11. Please remember that the straightener plates
are very hot after use.
12. Always switch the appliance off using the EIN/
AUS [ON/OFF] switch before disconnecting
the plug from the wall socket.
13. TIP: You can also curl your hair with the
straightener! Place the strand between the
plates as usual and straighten your hair.
Shortly before the ends of your hair, turn the
appliance to the inside or the outside (accord-
22
Copyright UNOLD AG | www.unold.de