SNOWSPORT HD Utility Plow Mode D'emploi page 5

a) At bottom of blade, check to make sure rubber edge is centered, then
drill a 3/16" pilot hole at factory mark in v-groove (4 locations) – drill
only through first layer of aluminum and into rubber. Repeat this drilling
procedure for three remaining marks.
a) Hang blade on push frame in the transport position and insert key hole
pins with tether cord attached.
b)
2
c) Turn 3/8" x 3/4" bolt into other hole
on handle and thread to nut in
channel. Handle should be flush
with blade edge. Then tighten both
bolts on lift handle. Repeat at other
end.