SNOWSPORT HD Utility Plow Mode D'emploi page 2

Note: Prior to plow assembly, park vehicle
on level grade and install plow mount
receiver (sold seperately). Clearance under
receiver should measure between 8 to 16
inches above grade.
Tools Needed (plow assembly):
• Ft. lb. torque wrench
• Impact or ratchet with 9/16" and
3/4" socket
• Drill with 3/16" and 5/16" drill bit
• #3 Phillips driver bit • 2 short pcs. of 2 x 4 blocking
• Box wrench 3/4" • Bubble level
• Open wrench 5/16" • Protective eyewear
• Allen wrench 3/16"
b) Push set collar tight against receiver –
hold and tighten set screw with 3/16" allen
wrench.