SNOWSPORT HD Utility Plow Mode D'emploi page 3

Blade Marker
End Plate
Slide Hinge
Bottom
Section of
Aluminum
Blade
Rubber Blade
Box End
Top
Section of
Aluminum
Blade
b) Slide end of rubber edge with matching
channel in bottom half of aluminum
blade and center on bottom half.
b) When both hinges are properly aligned –
they should measure 22 1/2" apart.
1
c) Turn bottom half of blade over and set it on wood blocks,
one at each end as shown. Take top half and connect
tongue and groove joint with bottom half. Slide top half
until centered with bottom half of blade.