Operating Instructions; Ray Selection Switch; Backlight; Unit Conversion For Dose Rate - REED R8008 Manuel D'utilisation

Operating Instructions

Press and hold the Power Button for 2 seconds to turn the meter on.
It will beep and the LCD screen will activate indicating it has turned on.
Press and hold the Power Button again to turn the meter off. Be sure to
turn the meter off properly or loss of data may occur.

Ray Selection Switch

Rotate the Ray Selection Switch to select the ray you wish to measure.
Be careful when rotating the switch to avoid damage to the sensor.
• Middle is for detecting Gamma Rays
• Left is for detecting Gamma and Beta Rays
• Right is for detecting Alpha, Gamma, and Beta Rays
• Any position will detect X Rays

Backlight

When the meter is on, press the Backlight Button to activate or deactivate
the LCD Backlight. The Backlight will automatically turn off after 1 minute.

Unit Conversion for Dose Rate

Press the Unit Button to measure in Standard Mode, which displays
the current measurement value in µSv/h. Press the Unit Button again to
convert the unit to mRem/h. The conversion is based on the formula:
10µSv/h = 1mRem/h.

Dose Accumulation Rate

Press the Dose Button to enter the Infinite Dose mode, and the icon "µSv"
will appear on the display. This mode accumulates calculations for no set
amount of time.
To enter the Timed Dose mode press the Dose Button again. The default
value of time is 60 minutes. Press the Dose Button again to stop the timed
measurement and the accumulated value will appear on the LCD. Press
the Dose Button again to return to Infinite Dose mode.
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com
Pantone 534 Blue - 100/80/30/5
Pantone 485 Red - 10/100/100/5
Pantone 534 Blue
Pantone 123 Yellow
Pantone 485 Red
Pantone 123 Yellow
Pantone 534 Blue
reedinstruments
www
Black
REED Instruments
Blue - 100/80/30/5
Yellow - 0/27/100/0
Red - 10/100/100/5
Yellow - 0/27/100/0
Blue - 100/80/30/5
Rich Black -
20/20/20/100
Only if you REALLY need them:
6
com