Pulse Sound Setup
When radiation is detected the meter will make a "ticking" sound. The
stronger the radiation signal is the faster the "ticking" sound will be.
1. Press the Setup Button and press the Up or Down buttons to select
the
Setup.
2. Press the Up and Down buttons to select either "ON" or "OFF".
3. Press the Enter Button to confirm the value, and press the ESC
button to save your settings and exit to the Setup Menu.
Average Measurement Time Setup
The processing measurement time can be set up from 8 to 120 seconds.
An increase of radiation will automatically and proportionally reduce the
Average Measurement Time. When the time is set to 8 seconds and the
radiation strength is more than 5µSv/h, the response time will adjust to 2
seconds. The factory default time is 30 seconds.
1. Press the Setup Button and press the Up or Down buttons to select
"T". Press the Enter Button to select the Average Measurement
Time Setup.
2. Press the Up and Down Buttons to adjust the flashing value.
3. Press the Enter Button to proceed to the next value, and press the
ESC button to save your settings and exit to the Setup Menu.
Bluetooth Data Transmission
1. Press the Setup Button and press the Up or Down buttons to select
"BL". Press the Enter Button to select the Bluetooth Data Transmis-
sion Setup.
2. Press the Up and Down buttons to select either "ON" or "OFF".
3. Press the Enter Button to confirm the value, and press the ESC
button to save your settings and exit to the Setup Menu.
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com
Pantone 534 Blue - 100/80/30/5
Pantone 485 Red - 10/100/100/5
icon. Press the Enter Button to select the Pulse Sound
Pantone 534 Blue
Pantone 123 Yellow
Pantone 485 Red
Pantone 123 Yellow
Pantone 534 Blue
reedinstruments
www
Black
REED Instruments
Blue - 100/80/30/5
Yellow - 0/27/100/0
Red - 10/100/100/5
Yellow - 0/27/100/0
Blue - 100/80/30/5
Rich Black -
20/20/20/100
Only if you REALLY need them:
10
com