Tripp-Lite SNMPWEBCARD Manuel D'installation page 14

Installation
4 - Test and Configure
Test Network Connection: After an IP address has been assigned to
4-1
the card, try to access it with a Web browser. Open a Web browser on
a computer connected to the LAN and enter http:// or https:// followed
by the IP address. You should be prompted for a password. The user
name is "localadmin" and the default password is "localadmin". After
you enter the user name and password, the PowerAlert Status page will
appear in the browser window. For more information about
configuration and operation of the managed device, refer to the
SNMPWEBCARD User's Guide, included on the CD-ROM bundled with
the card.
Default UPS System Shutdown Settings: During a power failure,
4-2
SNMPWEBCARD is pre-configured to shut down the UPS system two
minutes after receiving a low battery signal. This allows the UPS
system to provide the maximum available runtime to connected
equipment. If you want to change the default setting, follow these
instructions and refer to Figure 2-1:
13-01-199-933179.indb 14
14
4/23/2013 4:01:50 PM