Vmi® Link Pro App - VENTILAIRSEC VMI PUREVENT VISION'R Série Notice D'installation Et De Maintenance

4.2.2 VMI® LINK PRO app
First switch the VMI® on.
Once you have logged in to the app, a device pairing page suggests you select
the VMI® PUREVENT VISION'R unit to set up.
Select the VMI PUREVENT VISION'R unit shown in green or the one with the
number closest to 100.
Once paired, follow the app's process to enter the settings required to complete the set-up.
1– Surface area and height of the area to be ventilated
2- Preheating mode selection
Once these settings have been defined, the control unit and sensors (where
applicable) must be paired.
- To do this, simply add a device.
- Scan the QR code on the device to be added.
- Enter the room where the device is installed.
Sensors can be added after installation. To do so, simply log in to the VMI® unit
again via the app, select the SENSOR tab and follow the procedure described
above.
Once the devices have been added, enter information about the end customer to create the
warranty document.
o Electrics
o Hydro'R SMART
o Hydro'R PARTNER
3- Confirm, or not, the presence of a Purevent Bypass module
4- Indicate whether or not a VMI® LINK BOX is installed
5- Air renewal selection
4- Equivalent to 0.35 volume/h (for new houses)
5- Equivalent to 0.50 volume/h (ideal for renovations)
6- Equivalent to 0.60 volume/h (vulnerable persons)
37