Quick Operation Guide - Klarstein 10028327 Mode D'emploi

EN
52

QUICK OPERATION GUIDE

1 Switch on the Press the power button and open the door.
device
2 Fill with Fill the large compartment before each flushing programme.
detergent Fill the small compartment only for prewash programmes.
3 Check rinse aid Display C indicates whether there is still enough rinse aid in the
chamber.
4 Check rinsing Top up the rinsing salt as soon as the indicator light on the display lights
salt up.
5 Filling the Remove food residues from the dishes and soak pans with burnt-in food
dishwasher residues beforehand. Follow the instructions for loading the dishwasher.
6 Select program Close the door and press the program button until the desired program
lights up.
7 Starting the Turn on the tap and press the Start/Pause button. The program starts
dishwasher after 10 seconds.
Change program:
You can change the programme as long as the detergent has not
dissolved. If it has, you must refill it. Press the Start/Pause button for
3 seconds to cancel the current program. Select a new program and
start it.
Add crockery:
Press the Start/Pause button to pause the program. Open the door.
Add the crockery. Close the door and press Start/Pause. After 10
seconds the program continues.
If the device was switched off during the program:
If the program was switched off in the middle, select the program again
after switching on so that the dishwasher can continue at the point
where it was switched off.
8 Switch off the Once the program is finished, the buzzer sounds for 8 seconds. Press
appliance the Power button to turn the unit off. If you do not turn off the unit, it will
go into standby mode and automatically turn off after 30 minutes.
9 Turn off the Wait 15 minutes before removing the dishes, as the dishes are very hot
water tap, and sensitive after drying and could easily break. It also dries faster.
unload the You can remove the dishes after 15 minutes.
baskets