Wurth Master S 50 TB-M Notice D'utilisation page 7

S 50 TB-M - book Seite 7 Dienstag, 27. September 2005 8:44 08
Setting the Screw-in Depth
The required screw-in depth can be variably adjust-
ed by changing the setting of the knurled screw 8 on
the rear of the device.
8
The screw-in depth required is dependent on the ma-
terial to be worked and is best determined with prac-
tical trials.
Replacing the Screw Strip
Slide the screw strip into the holder guide 10; the
first screw of the screw strip must rest against the
transport hook
To ensure proper functioning of the automatic
transport mechanism, a return stroke must be per-
formed before beginning the screwdriving work
each time the screw strip is inserted/exchanged, in
order to bring the first screw into the working po-
sition.
Operating Instructions
Check the rotation direction of the screwdriver (if
reversible) before beginning the screwdriving
work. The screwdriving attachment must be oper-
ated only with the rotational direction switch in
the "right rotation" position.
Always drive in screws at a right angle to your
work.
Screws already driven cannot be loosened or
retightened with the screwdriving attachment.
For flawless functioning of the device, use only
screw strips in accordance with WÜRTH specifi-
cations.
Switch on the drive tool and apply the stop 9 to the
screwing location. Apply the screwdriving attach-
ment with uniform pressure against the material sur-
face until the clutch of the drive tool disengages
upon reaching the preset screw-in depth.
By briefly lifting the stop 9 from the material surface,
the next screw is transported into the working posi-
tion.
Note: When the screwdriving bit slips in the head of
the screw, lift off the screwdriving attachment imme-
diately, otherwise the screw head and the screwdriv-
ing bit will be damaged.
Adjustment (–):
Less screw-in depth,
The device is maintenance-free. When it becomes
the screw head pro-
soiled, simply free the moving parts from dust and
trudes.
dirt. Do not use lubricants.
Adjustment (+):
If the machine should fail despite the care taken in
Greater screw-in
manufacturing and testing, repair should be carried
depth, the screw
out by a Würth Master-Service agent.
head is imbedded.
For all correspondence and spare parts orders, al-
ways include the 10-digit order number of the at-
tachment!
For the current spare parts list of this machine, log into
the Internet under "http://www.wuerth.com/parts-
manager" or ask for a copy at your nearest Würth
branch office.
The plastic components are labelled for categorized
recycling.
For this Würth tool, we provide a warranty in
accordance with statutory /country-specific regula-
tions from the date of purchase (proof of purchase
by invoice or delivery note). Damage that has
occurred will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the warranty.
Claims can be recognised only when the tool is pre-
sented undisassembled to a Würth branch office or
a Würth field service employee.
Subject to change without notice
Maintenance and Cleaning
Environmental Protection
Recycling raw materials instead of
disposing as waste
Attachment, accessories and pack-
aging should be sorted for environ-
ment-friendly recycling.
Warranty
7