Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
Cooktop Installation
1. Visually inspect the cooktop for damage. Also make
sure all cooktop screws are tight (see Figure 8).
2. Install the retainer brackets (See Figure 9).
Figure 8
The retainer brackets MUST be installed, to meet local
codes or, in their absence, with the National Electrical
Code ANSI/NFPA No. 70—latest edition, or with CSA
Standard C22.1, Canadian Electrical Code, Part 1 (see
Figure 9).
Cooktop
Nylon
spacer
Retainer bracket
Figure 9
3. Set the cooktop into the countertop cutout.
NOTE: Do not use caulking compound; cooktop should
be removable for service when needed.
WARNING
Do not remove the nylon spacers on the
edges of the cooktop. These spacers center the cooktop
in the space provided. The cooktop must be centered
to prevent excess heat buildup that may result in heat
damage or fire (see Figure 10).
Screws
Countertop
2 Nylon
spacers
2 Retainer brackets
WARNING
The corners of this unit are fragile.
Carefully install the cooktop by its sides. When
installing, never let the weight of the unit rest on any
one corner.
Checking Operation
Refer to the Use and Care Guide for operation.
CAUTION
Do not touch cooktop glass or elements.
They may be hot enough to burn you.
Model and Serial Number Location
The serial plate is located under the cooktop.
When ordering parts for or making inquiries about your
cooktop, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your cooktop.
Before You Call for Service
Read the Before You Call for Service Checklist and
operating instructions in your Use and Care Guide.
It may save you time and expense. The list includes
common occurrences that are not the result of defective
workmanship or materials in this appliance.
Refer to your Use and Care Guide for Sears service
phone numbers, or call 1-800-4-MY-HOME
6
Figure 10
®
.
Publicité
Table des Matières
