Fuel S Ystem M Aintenance - LIFAN Power USA STORM Série Mode D'emploi

FUEL S YSTEM M AINTENANCE:
NOTE: P eriodically y ou c an g et s ediment o r t rash i n y our C arburetor B owl. U se t he
following p rocedures t o c lean:
1. Turn t he f uel v alve t o t he " OFF" P osition.
2. Remove t he M aintenance A ccess C over.
3. Remove t he c arburetor b owl b y r emoving t he m ounting b olt l ocated a t t he
bottom o f t he b owl.
4. Dump o ut t he o ld f uel a nd s ediment i nto a n a pproved c ontainer a nd c lean
carburetor b owl t horoughly.
5. Fit a n ew r ubber w asher i nto p lace a nd r e-­‐attach f uel b owl t o t he c arburetor.
NOTE: R emoval o f t he d rain s crew a t t he b ottom o f t he b owl c an d rain t he f uel t o
remove s maller d ebris t hat h as c ollected i n t he b owl.
6. After b owl i s s ecurely b ack i n p lace, t urn t he f uel V alve t o t he " ON" p osition f or
use.
7. Units e quipped w ith a p re-­‐filter f or f uel w ill h ave a f ilter h oused j ust b elow t he
fuel c ock. R emove t he f uel f ilter e lement ( refer t o " Fuel F ilter E lement R emoval"
diagram b elow) a nd e ither c lean o r r eplace t he f uel f ilter e lement. R e-­‐assemble
the f uel f ilter e lement ( refer t o " Fuel F ilter E lement A ssembly" d iagram b elow.)
F uel F ilter E lement R emoval F uel F ilter E lement A ssembly
8. Reinstall L eft A ccess P anel.
Maintenance ( continued)
R efer t o C ontrols a nd F eatures s ection f or d iagram.
29
LIFAN P ower U SA
2205 I ndustrial P ark R oad
Van B uren, A R 7 2956
866-­‐471-­‐7464
www.lifanpowerusa.com