PCM GSS-1530 Mode D'emploi page 2

English
1. To fix the tool holder on the machine,
introduce the shank and tighten the 3
fixation screws (1). Important, make sure
that the screws have the same strength of
tightening.
4
2
3
1
2. Mount the saw blade on the shaft (3),
using the flats provided for that purpose.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
GSS-1530
5
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation: 08.09.2015
3. Adjust the height of the saw blade . To do
that, block the spindle using the flats (2),
loosen the nut (4) and adjust the height
with the screw (5). When the correct
position is reached, tighten the nut (4).
4. Fix the shaft using the clamping nut, use
the flats (2) to block the spindle.
NOTE 1 : Never use the tool holder with
empty position. Use the supplied protection
plug.
NOTE 2 : Available shafts : Ø5mm/ 8mm/
10mm. Maximum saw blade Ø : 63mm.
Document:
GSS-1530 1- Mode
d'emploi
Page: 2 de 4
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email: office@pcm.ch