Luisi Air LODI SL89 Mode D'emploi page 6

* Filtering version
Fix the air deflector to the pipe bearing bra-
cket, by using the screws provided.
Fix the pipe bearing bracket to the wall and/
or ceiling (Fig. 8), centred to the hood.
Connect the motor air-outlet flange to the
air deflector, by using a suitable pipe. Per-
form the electric connection. Place the two
ornamental pipes on the hood body; lift the
internal pipe up until it reaches the ceiling;
then fix it to the pipe bearing bracket, by
using the two self-threaded screws provi-
ded.
Install the air outlet grill above the hood in
the relative seat (refer to Fig. 9). The stain-
less steel chimneys are not necessary.
WORKING
Mod. SL (Fig. 10)
A: Light switch on/off
B: Motor switch on/off (1st rate level)
C: 2nd rate level switch
D: 3rd rate level switch
E: 4th rate level switch
F: 10-minute timer.
MAINTENANCE
An accurate maintenance guarantees good
functioning and long-lasting performance.
Particular care is due to the grease filter.
It can be removed by following the instruc-
tions below:
Open the front glass panel, by acting on its
handle and rotate it outwards.
LED lamp replacement:
Open the glass panel, remove the grease fil-
ter and remove the LED lamp, by tightening
the fixing tongues, and pulling it outwards.
Replace the damaged LED lamp with one of
the same kind.
6