Luisi Air LODI SL89 Mode D'emploi page 5

If the appliance is equipped
with a power cord and a plug,
it shall be placed in such a
way that the plug can be rea-
ched easily.
* The use of materials which
can burst into flames (flam-
bé) should be avoided in
close proximity of the ap-
pliance. When frying, please
pay particular attention to
fire risk due to oil and gre-
ase. Being highly inflamma-
ble, fried oil is especially
dangerous. Do not use un-
covered electric grills.
In order to avoid possible
fire risk, all instructions
for grease-filter cleaning
and for removing eventual
grease deposits should be
strictly followed.
USES
The appliance has been designed to work
both in filtering and sucking mode.
* In the filtering version (fig. 1), the air and
fumes conveyed by the appliance are puri-
fied
by both a grease filter and an activated char-
coal filter, and then re-circulated into the
room through the side-grids of the chim-
ney. When the appliance works in this mode,
we recommend the use of an air deflector
(Fig.1A) to be placed on the upper part of
the pipe, allowing the air to be re-circulated
into the room .
* In the sucking version (fig. 2), fumes
are directly conveyed outside the building,
through the top or rear air out-let. The use
of a charcoal filter and air deflector is not
necessary in this case.
INSTALLATION
*Before installing the appliance, make sure
that none of the parts is damaged in any way.
In case of damaged parts, contact your re-
tailer and do not proceed with installation.
Read all of the following instructions care-
fully before installing the appliance:
- Use an air outlet pipe of the shortest pos-
sible length.
- Limit the number of pipe elbows.
- Use a material approved by standards and
regulations.
- Avoid any sudden changes in the pipe sec-
tion (recommended constant diameter: Ø
150 mm or equal surface area).
-The manufacturer shall not respond for
air capacity or noise problems due to non-
compliance with above mentioned instruc-
tions, and no warranty shall be given.
By using its drilling template (fig. 3A), drill
the holes for the installation; Appliances
shall be installed at a minimum distance of
450mm from the cook-top.
Install the dowell inside the holes and insert
two screws inside the two holes on the upper
part. Do not tighten the screws completely,
but leave about 2mm. between the wall and
the head of the screw. (Fig. 5)
Fix the hood on the wall, so that the two
screws perfectly coincide with the appro-
priate hook, placed on the back side of the
hood. (Fig. 6).
Open the front panel by rotating the lower
side upwards.
Remove the grease filter and fix the ap-
pliance to the wall with the screws provided.
* Sucking version
Fix the pipe bearing bracket to the wall and/
or ceiling by using the anchor screws and
screws provided (fig. 7), centred to the hood.
Connect the motor air-outlet flange to the
exhaust hole, by using a suitable pipe. Per-
form the electric connection. Place the two
ornamental pipes on the hood body ; lift the
internal pipe up until it reaches the ceiling;
then fix it to the pipe bearing bracket, by
using the two self-threaded screws provi-
ded.
5