Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
"POWER POINT" (AP735USA - SW 1.07)
USER MANUAL / MANUEL D'INSTRUCTIONS
The display symbols are very easy to understand :
A)
Four-digit display ( displays the measured value )
B)
Volt indicator
C)
Status bar
D)
Clock indicator
E)
A/h display
F)
Diode display
G)
Alarm display
H)
AC display
I)
Ampere display ( displays the current expressed in ampere )
L) DISPLAYED DATA
After the end of the charging process, with battery and mains connected, the following charging parameters
will be displayed. Values are recalled sequentially by pressing the RED ON-OFF button (outside).
Visual display for operation with time-controlled Final Charge (JS4 OFF)
Visual display 1
Visual display 3
Visual display 5
Visual display 7
P.B.M. S.r.l.
via Barella, Z.I. - VIGNOLA ( MO ) ITALIA
Tel. + 39 059 770 53 11 - Fax + 39 059 770 53 00
http://www.gruppopbm.it e-mail : pbm@gruppopbm.it
D
( displays the voltage value expressed in Volts )
( displays the existing voltage value in the battery )
( displays the time value expressed in hours and minutes )
( displays the charged Ampere-hours )
( signals a fault occurred in the DC section of the charger )
( signals a fault occurring during the charging process )
( signals a fault occurred in the mains supply )
DELIVERED CURRENT
BATTERY VOLTAGE BEFORE
THE CHARGING PROCESS
DELIVERED AH
VOLTAGE AT THE END OF
THE CHARGING PROCESS
A
B
C
E
F
G
H
I
pag. 10
file : POWER Point _USA+CAN_ Wa-WOWa_rev16.doc
Revision no. 16 dd. 21/04/2008
Visual display 2
INSTANTANEOUS
VOLTAGE
Visual display 4
CURRENT
AT
BEGINNING
OF
CHARGING PROCESS
Visual display 6
CHARGING TIME
Visual display 8
CURRENT AT THE END OF
THE CHARGING PROCESS
BATTERY
THE
THE
Publicité
Table des Matières
