Putting Into Operation - Abicor Binzel ABICUT 155 Mode D'emploi

6 Putting into operation

6 Putting into operation
EN - 10
The air-cooled plasma cutting torches in the ABICUT 155 series are
exclusively intended for the cutting of low and high-alloy materials using
compressed air for industrial or commercial use by trained operators.
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance,
servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close the gas supply.
• Disconnect the mains plug.
DANGER
Risk of injury and machine damage when handled by
unauthorised persons
Improper repair work and modifications to the product may lead to serious
injuries and damage to the device. The product warranty will be rendered
invalid if work is carried out to it by unauthorised persons.
• Operating, maintenance, cleaning and repair work may only be carried
out by qualified personnel (in Germany see TRBS 1203).
NOTICE
• Please take note of the following instructions:
 3 Product description on page EN-5
ABICUT 155