DeWalt DCN660 Mode D'emploi page 46

english
UNLOADING THE TOOL
1. Holding the tool upright, squeeze the latch
on pusher (H) and allow nails to slide down
magazine past the pusher.
2. Remove the nails from the magazine (I).
Adjusting the Driving Depth (Fig. 1)
Using the depth adjustment wheel, the nail driving
depth can be adjusted to the type of fastener used.
1. To drive the nail shallower, rotate the depth
adjustment wheel (K) towards the rear of the
tool. Refer to gauge (L) to understand where
the tool is set within the available range.
2. To sink a nail deeper, rotate the depth
adjustment wheel (K) towards the front of the
tool.
Selecting the Mode (Fig. 5)
DCN660 ONLY
To select sequential action mode, slide the mode
selector switch (J) to the single nail icon (
To select bump action mode, slide the mode
selector switch (J) to the three nail icon (
Trigger Lock-off (Fig. 6)
This tool is equipped with a trigger lock-off (M)
which prevents the tool from firing a nail.
To engage the trigger lock-off, push the switch
downward.
To release the trigger lock-off (M), pull the switch
upward.
WARNING: Make sure the trigger
lock-off (M) is engaged and the battery
pack is removed before making any
adjustments or when tool is not in
immediate use.
Non-mar Tip (Fig. 1)
Place the no-mark tip (N) over the contact trip (B)
when the tool is used on wood.
Store the no-mark tip at the holder (G) whenever it
is not to be used.
WARNING: Make sure the trigger lock-
off (M) is engaged and the battery pack
is removed before installing or removing
the no-mark tip.
Worklights (Fig. 1)
This tool has worklights (E) located on each
side. The worklights will light upon activating the
trigger or releasing the contact trip. The lights
will automatically go off after 10 seconds of non-
operation. The worklights also function as a low
battery indicator and a jammed nail indicator. For
44
further details, refer to Low Battery Indicator or
Clearing a Jammed Nail.
WARNING: The worklights are intended
for lighting the immediate work surface.
Do not use the worklights as the only
light source.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up can
cause injury.
Proper Hand Position (Fig. 9)
).
WARNING: To reduce the risk of serious
personal injury, ALWAYS use proper
hand position as shown.
).
WARNING: To reduce the risk of serious
personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Proper hand position requires one hand the main
handle.
Preparing the Tool (Fig. 1)
1. Remove battery pack and all nails from the
magazine.
2. Check if the contact trip (B) and nail pusher can
move freely.
3. Reload the nails to the magazine.
WARNING: Do not use the tool if the
contact trip or nail pusher cannot move
freely.
CAUTION: NEVER spray or in any
other way apply lubricants or cleaning
solvents inside the tool. This can
seriously affect the life and performance
of the tool.
Actuating the Tool (Fig. 1)
The DCN660 can be operated using one of two
modes: sequential action mode or bump action
mode.
The DCN661 operates in sequential mode only.