Keops Tm Solar Heater Installation; Primary Components - Kokido Keops K835 Manuel D'utilisation

TM
KEOPS Solar Heater Installation
Before installing KEOPS
the packag
e.
Primary Component
1 x Main base with 2 stand
1 x Flat gasket
(for connection of Threaded Nut
Hose connector to Threaded
Nut hose.)
1 x Long hose (Ø38mm /
1 1/2in) (for connection to
filter/pump)
The only tool you need is a screwdriver with which to secure the hose clamp for hose
connections to the hose connectors.
TM
Solar Heater, check to make sure all parts are present in
1 x Heater Dome Cover
(with cloth cover)
1 x Threaded nut hose
connector (preinstalled with O
ring inside)
1 x Short hose (Ø38mm /
1 1/2in) (for connection to
another heater)
2 x Hose reducer
Ø32mm(11/4in)–Ø38mm(1 1/2in)
2 x 32mm (1 1/4in) Hose
connector (preinstalled on the
water outlet/inlet under the main
base)
2 x Hose clamp
6