Connecting The Keops Tm Solar Heater To The Pool; For Pools Using Hose Connection Of Dia. 57Mm(2 1/4In) Soft - Kokido Keops K835 Manuel D'utilisation

Connecting the KEOPS
CAUTION
: Before beginning to connect this solar heater to your pool, make sure
your pool water outlet and return inlet are closed and already connected with hoses.
Refer to your pool manual or consult your pool dealer for proper instructions.
CAUTION
: Turn off the pump before following installation
1) For pools using hose connection of Dia. 32mm (1 1/4in) / 38mm (1 1/2in)
Soft Hose
a) Detach the pool return hose from your pump/filter.
b) For soft hose of Ø32mm (1 1/4in), directly slide the hose to the hose connectors as
far it can go. Use the hose clamp to secure the hose connection.
c) For soft hose of Ø38mm (1 1/2in), use either long hose provided or another soft
hose in same diameter to connect the pump/filter and middle hose connector. Firstly,
insert the hose reducer inside of cuff of long hose and slide it onto the hose connector
as far as it can go. Use hose clamp to secure the hose.
2) For pools using hose connection of Dia. 57mm (2 1/4in) soft hose with
Threaded Nut
a) Detach the pool return hose from your pump/filter.
b) Use soft hose of either Ø32mm (1 1/4in) or Ø38mm (1 1/2in) or to connect the
center hose connector to the pump/filter. Make sure the hose is secured by the hose
clamp.
c) Screw the threaded nut hose connector to the side hose connector. Make sure the
O ring is inside the threaded nut hose connector.
d) Screw the threaded nut of the hose, which is connected to the pool return inlet, to
the threaded nut hose connector. Make sure the flat gasket is placed between
threaded nut hose connector and hose threaded nut.
TM
Solar Heater to the pool
9